MIGHTYLAM 2700HC Betriebsanleitung Seite 1

OPERATING INSTRUCTIONS MIGHTYLAM 2700 ROLL LAMINATOR800-658-8788 www.abcoffice.comabcoffice

Threading Laminating Film...These instructions apply to poly-in film rolls (shiny side out, dull side in).1. For the top supply roll place the mandrel

5. Turn the Motor Switch on to start the Laminating and Pull Rollers.6. Feed a piece of thin cardboard about 10” x 25” against the film so that it is

The laminator temperature should be adjusted according to the film thickness and the itembeing laminated. See table 1 below for recommended temperatu

Caution! If the blade release knobs are turned too far,the slitter blade may fall out of its guide and come incontact with the rubber rollers. If th

10Note:You may want to run a test lamination first as any itemthat passes between the Heat Shoes will be laminated andcannot be recovered until it exi

Mounting & LaminatingThe ML27 is capable of simultaneously mounting and laminating a print on up to 3/16” mountboard.Mounting your print:1. Be su

TROUBLE SHOOTINGThe following guide will assist you with most problems that may be encountered whenlaminating.PROBLEM: Laminator is inoperative. Moto

PROBLEM: Blistering of the film appears over the item or along the edge.ACTION: Reduce temperature on one or both heat shoes. If the indicator lightr

146. Use a soft cloth moisentened with alcohol to remove any residue from the Teflon surface ofthe Heat Shoes and Laminating Rollers.7. Allow the Heat

PARTS LIST AND ILLUSTRATIONSThis section contains reference drawings and a parts list to assist you when ordering parts foryour laminator. The drawi

800-658-8788 www.abcoffice.comabcoffice

36 1170 Feet, rubber, large 437 1182 Fuse, 15amp, MDA-15 138 10509 Heater, 120v, 290w, mightylam 639 8288 Relay, solid state, 25A, DC 140 10

79 10354 Spring, thermometer, EZII 180 10355 Screw, cover, EZII 1081 10357 Block, terminal, 10 STA 182 547 Terminal ring blue 883 1459 Screw, set, 10-

116 589 Wire, 18 gauge, black 6.917117 598 Wire, 18 AWG, white/red 3.917118 7125 Wire, 18 AWG, white/violet 4.417119 596 Wire, 18 AWG, white w/blue 1.

19800-658-8788 www.abcoffice.comabcoffice

20800-658-8788 www.abcoffice.comabcoffice

21800-658-8788 www.abcoffice.comabcoffice

800-658-8788 www.abcoffice.comabcoffice

Safety Messages and Electrical Safeguards ...1-2Introduction ...

800-658-8788 www.abcoffice.comabcoffice

IMPORTANT SAFETY MESSAGES AND ELECTRICAL SAFEGUARDSFor your protection, do not connect the laminator to electrical power

 Unplug the laminator before moving it or when it is not in use for an extendedperiod of time as a precaution against the possibility of an internal

Your ML27 is preset at the factory for most applications so any adjustments should be mi-nor. A LCD readout provides continual indication of the Heat

INITIAL SETUPUnpacking...Before unpacking the unit, inspect the shipping container for signs of damage. Notifythe carrier and your dealer immediately

Motor Switch: This switch controls power to the Laminating Rollers. If the switch ispressed to the FWD (light will come on) position the rollers mov